PT-REQ80

_{1 With Quad Pixel Drive [ON].
2 Measurement, measuring conditions, and notation method all comply with ISO/IEC 21118: 2020 international standards. Value is the average of all products when shipped.
3 Average light output value of all shipped products measured at the center of the screen in NORMAL Mode.
4 Maximum physical resolution with Quad Pixel Drive [ON].
5 Only when the optional TY-SB01DL DIGITAL LINK Terminal Board is loaded.
6 Supports input signals up to 1080p. The display frame rate corresponds to the input signal frame rate.
7 Value is approximate. May vary depending on the input signal, peripheral devices, and other conditions.
8 The optional ET-SWR10 Software Development Kit (SDK) is used with third-party devices (sold separately). Compatibility with third-party devices cannot be guaranteed, and other limitations apply. For more information, please visit the ET-SWR10 webpage.
9 Maximum light output may decrease in the following situations: when a function board is installed in the slot, when voltage drops below AC 100 V, when the light source has deteriorated from use, or when dust has accumulated on the optical parts.
10 ET-FMP50 Series media processors are sold separately. For more information, please visit the ET-FMP50 Series webpage.
11 Optional proprietary and third-party function boards are sold separately. Panasonic cannot guarantee the operation of third-party devices.
12 The Dust Protected performance of this unit is not guaranteed to be free from damage or failure under all conditions (environment with conductive dust, etc.). Please use an enclosure in environments with smoke containing oil, salt, and moisture.
13 Around this time, the light output will have decreased by approximately 50 %. IEC62087: 2008 Broadcast Contents, NORMAL Mode, Dynamic Contrast [3], temperature 35 °C (95 °F), elevation 700m (2,297 ft) with 0.15 mg/m³ of airborne particulate matter. Panasonic recommends a checkup at the point of purchase after about 20,000 hours. Light-source lifetime may be reduced depending on the environmental conditions. Replacement of parts other than the light source may be required in a shorter period. Estimated maintenance time varies depending on the environment.}